ISOFIX Mounting Child Seat, Rear: Install
NOTE:
The following text describes how to install the ISOFIX mounting on the left-hand side, it can, however, also be installed on the right-hand side of the rear seat in the corresponding way.
- Fold the left-hand seat cushion and rear seat backrest forward.
- Grasp the upper edge of the left-hand side cushion A. Pull the side cushion forward so that the clips on the reverse release.
- Remove the side cushion by sliding it upwards.
- Remove the screw for the left-hand rear backrest mounting in the body. Fold up the bracket over the mounting in the backrest.
- Lift up the free end of the backrest and pull it off from the right.
- Position the backrest behind the backrest of the front seats.
- Pull off the rear edge of the floor carpet from the floor support. Fold the carpet to one side to expose the attachment points for the ISOFIX mounting in the floor.
- Remove the screws from the support bracket, new screws are in the kit.
- Remove the cover plug from the floor, it will no longer be used.
- Install the ISOFIX mounting, from the kit, over the weld nuts. Tighten the mounting using the two screws. Tighten to 40 Nm (30 lbf. ft.) .
- Fold the floor carpet back into place and insert the ISOFIX mounting's eyelets in the two cut-outs. Insert the rear edge of the floor carpet under the floor support. If necessary, pry up the floor support to make room.
- Reinstall the backrest. Tighten the screws to 40 Nm (30 lbf. ft) .
- Reinstall the side bolster.
- Fold the seat cushion back into place.