Child Seat, Mounting Kit (2004-2010): Install
- Install the left-hand mounting with the existing screw. Torque tighten the screw to 24 Nm (18 lbf. ft.) .
- Fold the floor carpet back under the mounting.
- Mark with a pen where the mounting eyelet shall go through the carpet.
- Make a small cut in the floor carpet opposite the marking, equally as wide as the mounting eyelet.
- Fold the carpet back over the mounting eyelet and refit it at the center console.
Image A applies to the S40 (04-)/V50, Image B applies to the C70 (06-)/C30
- Insert the mounting eyelet through the small cut in the floor carpet. Position the mounting over the hole and the guide pin in the seat rail with the washer on top.
- Reinstall the screw. Torque tighten the screw to 50 Nm (37 lbf. ft.) .
- Reinstall the cover panel over the seat mounting.