Checking The Wiring
- Ignition off.
Check the wiring between the keyless vehicle module (KVM) and the connector for the quick lock motor. Check for an open-circuit. Check for a short-circuit to ground. Check for short-circuit to supply voltage.
Other information
- see CONNECTING THE BREAKOUT BOX (2008, 2009, 2010, 2011)
- see DRIVER DOOR MODULE (DDM)
- see SIGNAL SPECIFICATION, KEYLESS VEHICLE MODULE (KVM) (2008, 2009, 2010, 2011)
- see PASSENGER DOOR MODULE (PDM)
- To access the front door control module, see: DRIVER DOOR MODULE (DDM)
- see CHECKING WIRING AND TERMINALS
Was a fault detected?
- YES
Refer to VERIFY
- NO
Refer to REPLACING THE COMPONENT