USB/IPOD Music Player, BLUETOOTH HANDSFREE: Reinstall

Fig 1: Identifying Glovebox Rear Section

Courtesy of VOLVO CARS OF NORTH AMERICA.

Dashboard 

• the lower vent.
• the sound proofing.
• the rear section of the glovebox by guiding it in diagonally inside the center console. Then straight forward. The rear section must be positioned on the outside of the remaining inner section.
• the clip for the vent on the glovebox.
• the panel on the dashboard end face.
• Remove the tape.
• the panel above the centre console. Check that the cable to the control panel is not pinched.

Passenger compartment 

• the B-pillar panel.
• the sill trim panels.
• the C-pillar panel.
• the rubber strips in the door openings.
• side cushions.
• Position the backrest and seat cushions back into place.

Cargo compartment 

• the side panels.
• the screws in the load securing eyelets. Tighten to 24 Nm (18 lbf. ft.)  .
• the sill trim panel for the tailgate.
• the upper floor support if applicable.
• the cargo compartment carpet.

Fig 2: Identifying VIDA (Service Information) To Program Software

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Download software (application) for the accessory's function according to service information in VIDA (Volvo scan tool). See VIDA or accessories catalogue for article number on software.

Fig 3: Control Panel Buttons

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Turn the ignition key to position I  .
• Turn on the radio.
• Check that the control panel for Bluetooth lights up.
• Press the button (1) in the middle of the control panel. The radio should mute and a voice should be heard.
• Press the button (2). The voice should now stop and the audio from the radio returns.