Connecting The Power Supply Cable

Fig 1: Identifying Subwoofer, Pre-Routed Single Pole Connector And Amplifier

Courtesy of VOLVO CARS OF NORTH AMERICA.

Connectors:

Fig 2: Identifying Connectors, Pre-Routed Black Connector And Relay

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: The previously installed fibre optic cable is not shown.

Plug connector (1) into the rear end face of the subwoofer.
Plug the connector (2) into the pre-routed black connector (5) which is taped on the cable harness at the rear edge of the left-hand rear wheel arch.
Detach the existing connector in the amplifier and plug it into connector (3) in the T-cable.
Plug the remaining connector (4) in the T-cable to the amplifier.
Clamp the relay (6) and all loose connectors in at the car's existing cable harness to prevent rattling.

Fig 3: Identifying Butyl Tape To Tape Cables For Subwoofer

Courtesy of VOLVO CARS OF NORTH AMERICA.

Using butyl tape, tape the cables for the subwoofer to the floor and straight back approximately 200 mm (7 7/8"). The cables must be positioned in the cut-out on the underside of the floor support when this is installed.

Fig 4: Identifying Left-Hand Small Floor Support

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take the left-hand small floor support from the kit and fit it in the rear left-hand corner of the cargo compartment.

Fig 5: Identifying Cables And Cut-Out

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ensure that the cables (1) for the subwoofer are positioned in the cut-out (2) on the underside of the floor support so that they are not trapped against the lower floor in the cargo compartment.

Fig 6: Identifying Floor Support

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 7: Identifying Right-Hand Lower Floor Support

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 8: Pressing In Adapter On Left And Right-Hand Upper Floor Supports

Courtesy of VOLVO CARS OF NORTH AMERICA.

Applies to cars with grocery bag holder on the cargo compartment floor

Prepare the upper floor support (E and F in the kit graphic):
Press in an adapter on the left and right-hand upper floor supports according to the existing marking as shown.

Fig 9: Identifying Sill Trim Panel

Courtesy of VOLVO CARS OF NORTH AMERICA.

Reinstall the sill trim panel in the boot lid opening using the existing clips.
Take the left-hand upper floor support (E in the kit graphic) from the kit. Install the floor support.
(If there is an adapter for grocery bag holder, then its clips should be in the opening of the sill trim panel.)

Fig 10: Identifying Right-Hand Upper Floor Support

Courtesy of VOLVO CARS OF NORTH AMERICA.

Applies to cars with a low cargo compartment floor

Take the right-hand upper floor support (F in the kit graphic) from the kit. Install the floor support.
(If there is an adapter for grocery bag holder, then its clips should be in the opening of the sill trim panel.)
Reinstall the side cushions
Take the new, wider cargo compartment carpet from the kit. Install the carpet.

Applies to cars with a high cargo compartment floor

Reinstall the right-hand upper floor support.
(If there is an adapter for grocery bag holder, then its clips should be in the opening of the sill trim panel.)
Reinstall the side cushions.
Reinstall the cargo compartment carpet.
(If it is a cargo compartment carpet with grocery bag holder then its two knobs should be in the corresponding holes in the adapter.)

Applies to all models