Installing The Microphone

Fig 1: Identifying Sun Visor Mounting

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Mounting Lock Plug

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying A-Pillar Weather Strip

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Locating Interior Lighting Catches

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the interior lighting by grasping the front edge and pulling downwards. It is held in place with six catches.

Fig 5: Identifying Three Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 6: Identifying Foam Tape Application

Courtesy of VOLVO CARS OF NORTH AMERICA.

Take two 700 mm pieces of foam tape from the kit.
Cut one piece of foam tape in the middle.
Tape one long and one short piece of foam tape on the microphone cable starting 70 mm from the microphone.

Fig 7: Identifying Microphone Cable

Courtesy of VOLVO CARS OF NORTH AMERICA.

Pull down the headlining with the interior lighting frame slightly.
Route the microphone cable along the top of the existing cable harness as shown.

Fig 8: View Of Microphone Cable Routing

Courtesy of VOLVO CARS OF NORTH AMERICA.

Route the microphone cable to the front edge of the headlining as shown.
NOTE: Position the cable so that it is not pinched when the sun visor mounting is refitted.

Fig 9: Identifying Trim Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 10: View Of Microphone Cable Positioning

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 11: View Of Cleaned Area

Courtesy of VOLVO CARS OF NORTH AMERICA.

Clean the microphone and roof panel in the area shown, which corresponds to the size of the double-sided adhesive tape. Use a solution of 25% isopropanol and 75% water, as well as a lint free cloth.
Dry with care, do not rub.
Allow to dry.

NOTE: In cases where the area is heavily soiled or treated with cockpit shine, first clean using a washing up detergent.

Remove the backing tape from one side of the Velcro strip and press it onto the microphone.

Fig 12: Identifying Microphone Placement

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the remaining backing tape from the Velcro strip and press the microphone securely onto the ceiling panel as shown.
NOTE: Direct the microphone towards the driver.

Feed in any cable excess.

Fig 13: Locating A-Pillar Cable Routing

Courtesy of VOLVO CARS OF NORTH AMERICA.

Route the cable to the A-pillar and onwards to the glove compartment.
Take three small tie straps from the kit and secure the cable at the A-pillar as shown.

WARNING: Make sure that the routing of the microphone cable does not interfere with the function of the inflatable curtain.