Center Loudspeaker
- Turn the ignition key to position 0.
- Remove the loudspeaker grille as follows: Insert tool P/N 999-5919-46 into the joint between the loudspeaker grille and the dashboard as shown in the illustration, until it engages
- Twist the tool 90° so that the bent section engages with the underneath of the loudspeaker grille.
- Pull upwards until the loudspeaker grille detaches. The loudspeaker grille is securely fastened by four clips. Move the tool closer to the clip to facilitate removal.NOTE:
Do not damage the dashboard.
- Remove the carpet covering the hole under the loudspeaker grille. Discard it, it will not be reused.
- Take the loudspeaker and six screws from the kit
- Connect the pre-routed connector to the loudspeaker
- Install the loudspeaker in the hole in the dashboard. Tighten using the six screws
- Press the loudspeaker grille into place.