Installing fender molding

Fig 1: Identifying Fender Molding

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

Always use a new molding when installing.

Remove any adhesive residue from the fender using white spirit.

Guide in the molding against the sill trim (1). Start at the rear edge.

Press the molding up towards the fender liner. Snap the molding into place on the fender.

Check that the clips click into the fender.

Remove the masking tape.

Install the six blind rivets.

NOTE:

Apply pressure to the trim so that the tape secures properly against the body.