Driver Information Module (DIM) signal description
All the values given below are measured between the respective connection in column 1 and connection 14 (signal ground) if not otherwise specified.
NOTE:
It is important that the test box is connected and the ground instructions checked before testing begins.
| U = | DC voltage (V) | f = | frequency in Hertz (Hz) |
| Ubat = | battery voltage (V) | t = | period time in milliseconds (ms) |
| Ulow = | Voltage close to 0V |
| Connect the test box | Connect. | Signal type | Ignition on | Idle | Other |
|---|---|---|---|---|---|
| 43 | 1 | Power supply Ext X | U=Ubat | ||
| 44 | 2 | Communication wire control units (CANH) | U=2.5-3.5V | ||
| 45 | 3 | Communication wire control units (CANL) | U=1.5-2.5V | ||
| 46 | 4 | Background lamp signal | Lamp off:U=Ubat Lamp on:U=Ulow |
||
| 47 | 5 | Brake fluid level signal (+) | Lamp off:U=Ubat Lamp on:U=Ulow |
||
| 48 | 6 | Parking brake signal (+) | Lamp off:U=Ubat Lamp on:U=Ulow |
||
| 49 | 7 | ||||
| 50 | 8 | Communication wire control units (CANH) | U=2.5-3.5V | ||
| 51 | 9 | Communication wire control units (CANL) | U=1.5-2.5V | ||
| 52 | 10 | ||||
| 53 | 11 | ||||
| 54 | 12 | ||||
| 55 | 13 | ||||
| 56 | 14 | Signal ground | U=Ulow | ||