Applies To All Models
- Take the cable harness with the rubber grommet from the kit.
- Pull in the end with four connectors through the hole in the car and fit the rubber grommet.
- Hook the connector (1) at the intended location under the tail lamp.
- Fit the cable with the clips (2).
Applies to cars with the Keyless system
- Plug the connector into the antenna (1).
Applies to others
- Secure the connector using a cable tie so that it does not rattle.
APPLIES TO ALL MODELS
- Install the parking assistance module on the right-hand side of the cargo compartment.
- Install it on the existing studs with nuts.
Connect:
- black connector to the control module's upper port.
- brown connector to the control module's lower port.
- Disconnect the existing 6-pin connector from the car's normal cable harness.
- Connect the connector to the cable harness for parking assistance.
- Secure the connectors to the panel edge.
Applies to cars with the Keyless system
- Plug the gray connector into the corresponding gray connector.