Remove the clamp from the inner boot (if the boot is being replaced)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clamp From Inner Gaiter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Cut the boot and remove it from the shaft.

NOTE: The outer constant velocity joint can be cleaned while assembled. Checking and cleaning, see Cleaning/checking the outer constant velocity joint .

NOTE: The inner constant velocity joint can be cleaned while assembled and blown clean prior to greasing. To disassemble the joint, see Clean and mark up the constant velocity joint , Separate the shaft and pull out the inner joint and Checking and inspection .

To assemble and lubricate the outer joint:

See Install the inner ring in the bearing race , Lubricate the constant velocity joint thoroughly , Replace the snap ring , Install the new boot(s) on the drive shaft , Apply grease in the boot and Vent the boot .