Removing the screws for the transmission and starter motor and the ground lead

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Transmission, Starter Motor And Ground Lead Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove:

the 3 screws for the transaxle/engine
the screw for the ignition setting sender (lift up the ignition setting sender)
the 2 screws for the starter motor. Remove the starter motor
the ground lead screw under the starter motor
the screw for the clamp holding the positive cable on the engine.

Tie the hoses and the cable harness to the intake manifold.