Transferring Components

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Sub-Frame Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

Transfer

the control arms. Use new screws and new nut. Tighten the front screws. Tighten to 65 Nm . Angle-tighten 90° . Use bevel protractor 9512050 . Tighten the rear screw. Tighten to 105 Nm . Angle-tighten 90°
the anti-roll bar. Tighten to 60 Nm
the right-hand engine mounting. Tighten the screws. Tighten to 65 Nm . Angle-tighten 60°
the mounting for the heated oxygen sensor (HO2S) wiring
the engine pad.

Install new pipe / hose holders.