Removing the throttle body

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Charge Air Pipe With Hose Clamp

Courtesy of VOLVO CARS OF NORTH AMERICA.

Slacken off the hose clamp for the charge air pipe on the throttle body (TB).

Remove the charge air pipe from the throttle body.

Fig 2: Identifying Cylinder Block Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION:

The wiring to the throttle body must not be cut off. The throttle body may need to returned complete.

If the wiring to the throttle body is behind the bracket for the starter motor:

Slacken off the nuts (x 2).

Remove the screw.

Remove any tie straps and disconnect the connector for the throttle body.

Route the wiring for the throttle body from the reverse of the bracket for the starter motor.