LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2007 >> S60 T-5, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 202 (Throttle Body (Electronic Throttle Module) - Removal And Installation) >> Engine Mechanical >> Throttle body (electronic throttle module (ETM)), replacing >> Throttle body (electronic throttle module (ETM)), replacing (B5xx4T -2001) >> Removing >> Removing the fan shroud

Removing the fan shroud

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Air Cleaner Inlet Pipe And Engine Cooling Fan Connector
GLL154875Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the inlet pipe to the air cleaner (ACL) housing.

Disconnect the 2 x connectors, for the engine cooling fan (FC).

Remove: 

NOTE:

Certain vehicles have three tie straps and a clip holding the cable harness at the fan shroud.

Lift out the hose for the expansion tank from the holders on top of the fan shroud

Remove both the screws holding the fan shroud

Carefully lift up the engine cooling fan (FC).