Calibrating the component

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Calibration can only be performed if the vehicle is equipped with an occupant weight sensor (OWS).

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

Switch off the ignition. Wait 10 seconds
Ensure that the passenger seat is completely empty
Switch on the ignition. Wait 10 seconds.
CAUTION:
The passenger seat must be completely empty during calibration. If the passenger seat is not completely empty, the calibration will be incorrect, which will result in incorrect function of the SRS system.

Activate calibration of the occupant weight sensor (OWS) by clicking on the VCT2000 symbol.

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS OF NORTH AMERICA.