Activating Lamps

Fig 1: Identifying Ignition ON

GLL101051

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition on
Activate the system test procedures and check whether the relevant needle or lamp operates correctly. All needles must move from minimum to maximum and back again, and the lamps must flash (except for the MIL and the indicator light for the turn signal lamps).
The light level in the instrumentation is also checked.

All parts of the instrumentation flash.

Remedy as necessary

Other information:
- To replace the lamps, see Driver Information Module (DIM), Replacing
- To replace the combined instrument panel, see Driver Information Module (DIM), Replacing .
Fig 2: Identifying VCT2000
Courtesy of VOLVO CARS OF NORTH AMERICA.