Installing Upper Control Arm

Fig 1: Installing Front Bushing And Aligning In Correct Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Press Tool 999 5739 Into Control Arm

Courtesy of VOLVO CARS OF NORTH AMERICA.

Screw press tool (A) 9995739 into place on the control arm. Use one M12x65 mm screw (B) and the bushing.
NOTE:
Check that the markings on the bushing and the sub-frame are opposite each other.

Fig 3: Threaded Shaft Into Place On Control Arm

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Puller Cylinder 999 5575 Into Threaded Rod

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 5: Pressing Control Arm Up To Toothed Segment

Courtesy of VOLVO CARS OF NORTH AMERICA.

Press the control arm up to the toothed segment.
NOTE:
Do not press in the control arm so far that the toothed segment goes into the rear bushing.

Fig 6: Installing M12X70 mm Screw With A Nut In Hole For Anti-Roll Bar On Control Arm

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install a M12x70 mm screw with a nut in the hole for the anti-roll bar on the control arm, as a help when measuring.
Check the height measurement on the control arm. If necessary adjust the height measurement with a tie strap.

Fig 7: Tightening Control Arm Into Rear Bushing

Courtesy of VOLVO CARS OF NORTH AMERICA.

Tighten the control arm into the rear bushing.
NOTE:
If the front bushing reaches the bottom before the rear bushing remove the press tool (5739-1).

Tighten the control arm until it bottoms against the rear bushing.

Fig 8: Removing Puller Cylinder With Screw

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the puller cylinder with the screw.

Install the front and rear (large washer) screws in the control arm. Tighten to 50 Nm .

Remove