Installing The Rear Axle (Continued)

Fig 1: Centering Sleeves In Two Rear Mountings On Sub-Frame

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Slide up the centering sleeves 9997017 in the two rear mountings on the sub-frame
• Install the screw. Tighten lightly
• Install the screws for the front mountings on the sub-frame. Install the screws through the brackets
• Tighten all the front mountings. Tighten to 80 Nm 
• Remove the screws for the rear mountings on the sub-frame. Remove the centering sleeves 
• Install the screws for the rear mountings on the sub-frame. Tighten to 80 Nm  .

Install: 

• the brake pipes in the plastic clips on the brackets
• the screw for the fuel filter bracket (24Nm)
• the screw for the brake line mounting stays (24 Nm).

Remove the lifting table.

Install: 

• the brake pipes in the plastic clips on the brackets
• the screw for the fuel filter bracket. Tighten to 24 Nm 
• the screw for the mounting stay for the brake lines. Tighten to 24 Nm  .

Remove the lifting table.

Install: 

• rivets to the heat shield on the sub-frame left rear bushing
• the plastic nut for the fender liner.