Finishing Work (AWD)

Fig 1: Screws For Shock Absorber Mounting

Courtesy of VOLVO CARS OF NORTH AMERICA.

Press the suspension up to its normal position, see Normal position .

Tighten: 

• the outer mounting for the tie rod. Tighten to 80 Nm 
• the rear mounting for the lateral link. Tighten to 80 Nm 
• the outer mounting for the lower control arm. Tighten to 80 Nm 
• the outer mounting for the upper control arm. Tighten to 80 Nm 
• the inner mounting for the upper control arm. Tighten to 80 Nm  .

Install the retaining strap and pull down the control arms so that the shock absorber can be installed.

Install: 

• the shock absorber
• the screws. Tighten to 80 Nm  .

Remove the tensioner strap.