Checking the power supply wiring
WARNING: This page is about a different variant/trim than selected.
Check the wiring between the central electronic module (CEM) #2E (#B22), to the relevant courtesy lighting #2. Check for an open-circuit. Check for a short-circuit to ground.
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box
- For information about signals, see Signal specification
- To access or replace the front courtesy lighting, see Courtesy lighting, front, replacing .
Does the courtesy lighting function?
- YES
Refer to Verification
- NO
Refer to Light switch replacement