Checking the WHIPS System, Version Two

NOTE: The WHIPS system must be checked after every collision

NOTE: The graphic shows the left-hand side mounting. The right-hand side is the mirror image.

The nut always faces the center of the seat.

(A) = reference mark. Always the second outermost section of the WHIPS mounting.

(B) = deformation element in the WHIPS mounting.

Fig 1: Backrest Folded Back

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fold the backrest backwards.

Fig 2: Checking That Marking/Edge Of Deformation Element Is Not In Front Of Reference Mark

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that the marking/edge of the deformation element (B) is not in front of the reference mark (A) as shown.

If the deformation section (B) is in front of the reference mark, the deformation element must be replaced. See Replacing WHIPS for mechanical front seats. See Replacing WHIPS for power seats.

NOTE: The deformation element must be replaced if it is deformed.

NOTE: Always check both the right and left sides of both front seats.