Resetting Crash Mode (2009-2013): Verification

HINT: After carrying out the repair check that the fault has been remedied. 

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS CORPORATION

• Switch off the ignition. Wait 10 seconds
• Disconnect the battery negative lead
• Reinstall the connectors, components etc.
• Ignition on
• Connect the battery negative lead. Wait 10 seconds.
  WARNING:

  There must not be anyone inside the passenger compartment when the battery is connected.

  Read diagnostic trouble codes by clicking the VCT2000 (Volvo Scan Tool) symbol.

  If the fault is intermittent, the fault has been remedied.

  Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS CORPORATION

Is the fault intermittent? 

• YES 

  VERIFIED:  Troubleshooting has been completed.

• NO 

  Refer to INFORMATION