Checking Components And Wiring
Check that fuse 11D/2 is intact.
Check that shunt 20/29 is not damaged. The resistance between the terminal pins is 0 ohm to 5 ohms depending on which pin the reading is taken at.
Check the cables between:
fuse 11D/2 terminal #2 and rear electronic module terminal #4E
shunt 20/29 terminal #2 and relay 2/49 terminal #5
relay 2/49 terminal #3 and the left or right lower lamp housing terminal #3
for an open-circuit according to OPEN-CIRCUIT, PERMANENT FAULTS and a short-circuit to ground according to SHORT-CIRCUIT TO GROUND, PERMANENT FAULTS .
Check the cable between the left or right lower lamp housing terminal #4 and the ground terminal for an open-circuit according to OPEN-CIRCUIT, PERMANENT FAULTS .
Check that the bulbs are intact.
Remedy as necessary.
Other information:
- For further information about signals and other values, see SIGNAL SPECIFICATION
- To connect the breakout box, see CONNECTING THE BREAKOUT BOX .
- To access the integrated relay/fusebox in the cargo compartment, see RELAY/FUSE BOX CARGO COMPARTMENT/REAR ELECTRONIC MODULE (REM), REPLACING .
- Shunt 20/29 is marked SH2 on the integrated relay/fusebox in the cargo compartment. Terminal #2 on the shunt can be identified on the reverse of the integrated relay/fusebox.