Throttle body (electronic throttle module (ETM)), replacing: Removal

Preparation 

Fig 1: Intake Manifold Between Front Cover Plate And Air Cleaner Housing

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove: 

• the air intake between the front cover plate and the air cleaner (ACL) housing
• the charge air pipe between the charge air cooler (CAC) and the electronic throttle module (ETM).

Removing the electronic throttle module (ETM) 

Fig 2: Identifying Electronic Throttle Control Module And Throttle Body

Courtesy of VOLVO CARS OF NORTH AMERICA.

Disconnect the connector for the electronic throttle module.

Remove the 4 x screws for the electronic throttle module (ETM). Lift out the electronic throttle module (ETM). Discard the gasket.