Signal Too High. Permanent Fault: Verification: Verification

HINT: After the repair it is necessary to check that the fault has been rectified. 

Fig 1: Identifying Engine START Position

Courtesy of VOLVO CARS CORPORATION

Fig 2: Connecting Connector

Courtesy of VOLVO CARS CORPORATION

• Ignition off.
• Connect connectors, install components, etc.
• Key in position III.

  Check that X-voltage is OK.

  Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS CORPORATION

Is voltage on the wire low? 

• YES 

  VERIFIED:  Troubleshooting has been completed.

• NO 

  Refer to INFORMATION