Checking The Component
- Ignition off
- Disconnect the connector from the front right front impact sensor.
Check the female and male parts of the connectors for the Supplemental Restraint System Module (SRS) and the front impact sensor. The cable terminals must not be damaged, pressed back or oxidized.
Connect special tool see 9512887 to the front impact sensor.
Check the resistance between terminal #21B (49) and #20B(48) on the Supplemental Restraint System Module (SRS). The resistance should be 10KΩ.
Remedy as necessary.
Other information:
- To access or replace the front impact sensor, see COLLISION SENSOR FRONT, REPLACING
- For information about signals, see SIGNAL SPECIFICATION
- For information about the repair of SRS wiring, see CABLE HARNESS SRS SYSTEM, REPAIR
- see CHECKING WIRING AND TERMINALS .
Is the correct resistance value displayed?
- NO
- YES
See: VERIFICATION
- Ignition off
- Disconnect special tool
see 9512887
from the front impact sensor.
Check the female and male parts of the connectors for the Supplemental Restraint System Module (SRS) and the front impact sensor. The cable terminals must not be damaged, pressed back or oxidized.
Check the cable between the Supplemental Restraint System Module (SRS) terminal #21B (49) and front right front impact sensor #1. Check for an open-circuit.
Check the cable between the Supplemental Restraint System Module (SRS) terminal #20B (48) and front right front impact sensor #2. Check for an open-circuit.
Remedy as necessary.
Other information:
- To access or replace the front impact sensor, see COLLISION SENSOR FRONT, REPLACING
- For information about signals, see SIGNAL SPECIFICATION
- For information about the repair of SRS wiring, see CABLE HARNESS SRS SYSTEM, REPAIR
- see CHECKING WIRING AND TERMINALS .
- Continue
See: VERIFICATION