Checking the signal cable
- Ignition off.
Check the signal cables below for both the rear doors. Check for a short-circuit to supply voltage. Check for an open-circuit. Check for a short-circuit to ground.
- Between lock unit connector terminal #3 and the relay holder in the door, terminal #4
- Between the relay holder in the door, terminal #3 and rear electronic module (REM) relay position 2/115 terminal #3.
Remedy as necessary.
Other information:
- To access the lock unit in the rear door, see Lock mechanism rear side door, replacing
- To access the integrated relay / fusebox in the cargo compartment, see Integrated relay / fusebox cargo compartment / rear electronic module, replacing
- See Checking wiring and terminals .
- Continue
Refer to Verification
- Ignition off.
Check the signal cables below for both the rear doors. Check for a short-circuit to supply voltage. Check for an open-circuit. Check for a short-circuit to ground.
- Between the relay holder in the door, terminal #2 and ground
- Between the relay holder in the door, terminal #1 and central electronic module (CEM) relay position 2/120 terminal #3.
Remedy as necessary.
Other information:
- To access the central electronic module (CEM), see Central electronic module (CEM), replacing
- To connect the breakout box, see Connecting the breakout box
- See Checking wiring and terminals .
- Continue
Refer to Verification