Checking the wires

Check and measure the wire between combined instrument 4 and engine control module connector B 46 for an open circuit as described in Open-circuit, permanent faults , and a short circuit to voltage supply as described in Short-circuit to supply voltage. Permanent faults .

Additional information: 

• To connect the test box, see Connecting the Driver Information Module (DIM) test box .

Fig 1: Identifying Ohmmeter

Courtesy of ABLE BODY CORP.

Is there a fault? 

• YES 

  Refer to Verification 

• NO 

  FAULT NOT FOUND:  Troubleshooting has been completed.