LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> V70 R, Standard >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Crankcase Ventilation, Intake And Exhaust System - Cleaning, Inspection And Adjustment >> Crankcase Ventilation And Electronic Throttle Module (ETM) (B5234T3; B5244T3; 2001) >> Crankcase ventilation and electronic throttle module (ETM), cleaning >> Installing >> Installing the fan shroud

Installing the fan shroud

Fig 1: Identifying Cable Harness, Tie Straps And Harness Holder
GLL147982Courtesy of VOLVO CARS OF NORTH AMERICA.

Carefully lower the fan shroud and align with the holders. Route the cable harness behind the holder (3).

Tighten the 2 x mounting screws.

Press the hose down from the expansion tank into the holder on the fan shroud

Secure the cable harness by the fan shroud using tie straps (1) and (2), see the illustration.

Install the evaporative emission system (EVAP) valve.

Connect the engine cooling fan (FC) connectors.

Fig 2: Identifying Charge Air Hose
GLL105835Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

Fig 3: Identifying Power Steering Pump And Mounting Screws Location
GLL107851Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

Fig 4: Identifying Power Steering Pump Hose, Pressure Line And Hose Clamp
GLL153574Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the delivery pipe on the power steering pump. Use a new O-ring on the pressure line.

Remove the hose clip.

scientia non olet · About LEMON Manuals