Circuit test continued

Measure the resistance between terminal #1 and ground and between terminal #2 and ground on the cable connector.

The ohmmeter should read 0 ohm.

1. The ohmmeter displays a fault between terminal #1 and ground. Refer to Checking the unlocking relay circuit 
2. The ohmmeter displays a fault between terminal #2 and ground. Refer to Checking the locking relay circuit 

Fig 1: Identifying Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.