Checking the cable
- HINT: The fault could also have been caused by the tailgate wiper sticking.
Check fuse 11D/12.
Check the cable between fuse 11D/12 #2 and rear electronic module relay base 2/16 #3. Check the cable between fuse 11D/12 #2 and rear electronic module relay base 2/72 #3. Check for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults . Check for an open-circuit according to Open-circuit, permanent faults .
Check the cable between rear electronic module relay base 2/16 #1 and wiper motor 6/32 #2. Check the cable between rear electronic module relay base 2/72 #1 and wiper motor 6/32 #1. Check for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults . Check for an open-circuit according to Open-circuit, permanent faults .
Check the cable between wiper motor 6/32 #3 and ground terminal 31/72. Check for a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults . Check for an open-circuit according to Open-circuit, permanent faults .
If no other faults are found try a new tailgate wiper motor (6/32).
Remedy as necessary.
Other information:
- To access the integrated relay / fusebox in the cargo compartment, see Relay/fuse box cargo compartment/Rear electronic module (REM), replacing .
- For information about signals, see Signal specification .
- Continue
Refer to Verification