LEMON Manuals: Even more car manuals for everyone
Home >> Volvo >> 2004 >> V70 Base, 2.4 64 >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Drive Shaft Seal (Right), Turbocharger - Removal & Installation >> Engine >> Replacing The Wiring Harness / Oil Temperature Sensor >> Removal >> Removing Lifting Beams And The Lifting Hook

Removing Lifting Beams And The Lifting Hook

Fig 1: Identifying Gear-Shift Position Sensor
GLL109388Courtesy of VOLVO CARS OF NORTH AMERICA.

Twist in the tab on the cable harness holder.

Install the screw for the gear-shift position sensor and holder. Tighten to 25 Nm  .

Install the lever on the gear shift linkage rod. Tighten the nut. Tighten to 16 Nm  .

scientia non olet · About LEMON Manuals