Remove The Gearbox Cable From The Lever On The Gearbox

Fig 1: Identifying Small Connector In Bracket, Connectors On Transmission And Transmission Wiring To Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove: 

• the gearbox cable from the lever on the gearbox
• the two screws for the cable bracket. Move the cable to one side.

Remove: 

• the connector from the gearbox
• the tie strap holding the cable harness.

Separate the connectors.

Remove the small connector from the bracket.

Applies only when replacing the control system 

Set the gearbox lever to the neutral position. Move the lever as far forward as possible to position P and then back two steps to neutral.