If the vehicle has lock brackets

Fig 1: Identifying Lock Bracket And Screw

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the lock bracket (2).

Tighten the screw (1).

NOTE:

There may be a gap (3) of a few millimeters between the pipe coupling and the power steering pump. Bend the bracket so that the twelve edged mounting on the bracket is on the nut.

Install:

the auxiliaries belt. Use 9997109
the servo reservoir in its mounting on the expansion tank
the tie strap around the servo hose at the spring strut turret
the servo hose in the holder on the belt cover on the power steering pump
the connector with holder on the power steering pump.

Fig 2: Identifying Charge Air Hose

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the charge air hose on the charge air cooler (CAC).
the screw for the charge air pipe above the engine and clamp for power steering pump delivery lines from the intake manifold
cold air inlet hose to control module.

Check the level in the servo reservoir and top up if necessary.

Install:

the battery negative cable. Battery, disconnecting

Start the engine and check for leakage.