Activating Lamps

Fig 1: Identifying Ignition On Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition on
• Activate the system test procedures. Check whether the relevant needle or lamp operates correctly.

  All needles must move from min to max and back again.

  The lamps must flash (not the malfunction indicator lamp (MIL) or turn signal indicator lamps).

  The light level in the instrumentation is also checked.

  All parts of the instrumentation flash.

  Remedy as necessary.

  Other information: 

  • See Driver information module (DIM), replacing
  Fig 2: Identifying VCT2000

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Was a fault detected? 

• YES 

  OKAY:  Troubleshooting has been completed.

• NO 

  FAULT NOT FOUND:  Troubleshooting has been completed.