Checking the wiring and component
- Ignition off
- Open the transmission control system.
Check the cable between transmission connector terminal #C5 (transmission side) and the connector for solenoid S5. Check for an open-circuit according to Open-circuit, permanent faults .
Check solenoid S5 by measuring the resistance between the terminal pin on solenoid S5 and the transmission housing. The resistance must be 11-15 Ω. Replace solenoid S5 if the resistance is incorrect.
Remedy as necessary.
Other information:
- To disconnect the transmission connectors, see Connectors transmission, disconnecting / connecting
- To open the control system and to check or replace solenoid S5, see Solenoid control system, replacing
- To replace the cable harness for the control system, see Cable harness/oil temperature sensor, replacing
- For information about signals, see Signal description. Transmission control module (TCM) .
- Continue
Refer to Resetting the adaptation