Checking the wiring
- Ignition off
- The breakout box connected
- Transmission connector C disconnected.
Check the cable between control module terminal #A47 (#A47) and transmission connector terminal #C4 (control module side). Check for an open-circuit according to Open-circuit, permanent faults .
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box
- To disconnect the transmission connectors, see Connectors, transmission, disconnecting / connecting
- For information about signals, see Signal description. Transmission control module (TCM) .
Was a fault detected?
- YES
Refer to Verification
- NO
Refer to Checking the control module