Checking the wiring
- Ignition off
- Transmission connector C disconnected.
Check the cable between control module terminal #A48 (#A48) and transmission connector terminal #C3 (control module side). Check for a short-circuit to ground according to Short-circuit to ground, permanent faults .
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box
- To disconnect the transmission connectors, see Connectors, transmission, disconnecting / connecting
- For information about signals, see Signal description. Transmission control module (TCM) .
Was a fault detected?
- YES
Refer to Verification
- NO
Refer to Checking the control module