Checking the wiring

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.

  Check the cable between control module terminal #A48 (#A48) and transmission connector terminal #C3 (control module side). Check for an open-circuit according to Open-circuit, permanent faults .

  Remedy as necessary.

  Other information: 

  • To connect the breakout box, see Connecting the breakout box
  • To disconnect the transmission connectors, see Connectors, transmission, disconnecting / connecting
  • For information about signals, see Signal description. Transmission control module (TCM) .
  Fig 2: Identifying Transmission Connector Terminals

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 3: Identifying Ohm Meter

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Was a fault detected? 

• YES 

  Refer to Verification 

• NO 

  Refer to Checking the control module