Checking the wiring and component

Check the cable between the gear selector module (GSM) and the solenoid connectors. Check for a short-circuit to supply voltage. See Short-circuit to supply voltage. Permanent faults .

HINT: With a voltmeter connected to solenoid connector terminals #1 and #2 (gear selector control module side), the voltage should be 0 V when the brake pedal is not depressed and approximately Ubat when it is depressed. Replace the solenoid if the voltage is OK 

Remedy as necessary.

Other information 

• To check or replace the shift lock solenoid, see Solenoid, back-up (reverse) inhibitor, replacing .

• Continue 

  Refer to Verification