Checking for contact resistance and oxidation
- Ignition off
- Check connectors and connections for contact resistance or oxidation.
Measure the resistance on the terminals for solenoid SLU. Check for an open-circuit. Check for a short-circuit to ground.
Remedy as necessary.
Other information
- See Checking wiring and terminals. Permanent fault
- To access transmission connectors, see:
- To access the control module connector, see:
- See Solenoid control system, replacing
- Continue
Refer to Test driving the transmission
- Ignition off
- Check connectors and connections for contact resistance or oxidation.
Measure the resistance on the terminals for solenoid SLU. Check for an open-circuit. Check for a short-circuit to ground.
Remedy as necessary.
Other information
- See Checking wiring and terminals. Permanent fault
- To access transmission connectors, see:
- To access the control module connector, see:
- See Solenoid control system, replacing
- Continue
Refer to Test driving the transmission