Checking the wiring
- Ignition off
- The transmission connector disconnected.
Check the cable between control module terminal #51 (#A51) and transmission connector (control module side) terminal #T (#A17). Check for a short-circuit to ground. See Short-circuit to ground, permanent faults .
Check the cable between control module terminal #A53 and transmission connector (control module side) terminal #E (#A5). Check for a short-circuit to ground. See Short-circuit to ground, permanent faults .
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box
- To connect the breakout box to the transmission connector, see Connecting the breakout box, GM automatic transmissions
- For information about signals, see Signal specification .
Was a fault detected?
- YES
Refer to Verification
- NO
Refer to Checking the control module