Checking lock-up solenoid SL

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector(s) Reinstallation

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.

  Check the control module and automatic transmission connectors for contact resistance and oxidation according to Contact resistance and oxidation . Remedy if necessary

• Ignition on
• Reinstall the components, reconnect the connectors etc.
• Gear selector in position P
• Activate the lock-up solenoid SL.

  The value must change between OFF and ON.

  Other information: 

  • To disconnect the control module, see Transmission control module (TCM), replacing
  • To disconnect the transmission connector, see Connecting the breakout box, GM automatic transmissions
  • For information about signals, see Signal specification .
  Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Does the value change? 

• YES 

  OKAY:  Troubleshooting has been completed.

• NO 

  Refer to Checking solenoid SL