Checking the software

NOTE: To carry out fault-tracing, the transmission control module (TCM) must be programmed with specific software.

Fig 1: Identifying Ignition ON

GLL101051

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition on
Read off the control module diagnostic number.
Check the read off diagnostic number against the diagnostic numbers given in the center table.

If the diagnostic number is included in the table, the control module must be programmed with the latest software.

See the technical journal for information about the most recent software.

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Transmission Control Module (TCM)
Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Test driving

NOTE: To carry out fault-tracing, the transmission control module (TCM) must be programmed with specific software.

Fig 1: Identifying Ignition ON

GLL101051

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition on
Read off the control module diagnostic number.
Check the read off diagnostic number against the diagnostic numbers given in the center table.

If the diagnostic number is included in the table, the control module must be programmed with the latest software.

See the technical journal for information about the most recent software.

Fig 2: Identifying VCT2000 Diagnostic Tool Symbol In VIDA
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Transmission Control Module (TCM)
Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Test driving