Checking the wiring

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector(s) Disconnected

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Control Module Disconnected

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off
• Connect the breakout box
• Disconnect the control module.
• Disconnect the transmission connector
• Connect adapter 9511505 and breakout box 9813190 to the transmission connector (transmission side).

  Check the cable between control module terminal #A68 (#B8) and transmission connector terminal #B (#A2) (control module side). Check for a short-circuit to ground. See Short-circuit to ground, permanent faults .

  Check the cable between control module terminal #A53 and transmission connector (control module side) terminal #E (#A5). Check for a short-circuit to ground. See Short-circuit to ground, permanent faults

  Remedy as necessary.

  Other information: 

  • To connect the breakout box, see Connecting the breakout box
  • To connect the breakout box to the transmission connector, see Connecting the breakout box, GM automatic transmissions
  • For information about signals, see Signal specification .
  Fig 4: Identifying Breakout Box

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 5: Identifying Ohms Display

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Was a fault detected? 

• YES 

  Refer to Verification 

• NO 

  Refer to Checking the control module