Intermittent fault
Check the control module and automatic transmission connector. Check for contact resistance and oxidation. Remedy if necessary.
Check the cable between control module terminal #A37 (#A37) and transmission connector (control module side) terminal #11. Check for an intermittent open-circuit. Check for an intermittent short-circuit to supply voltage.
Check the cable between control module terminal #A55 (#A55) and transmission connector (control module side) terminal #12. Check for an intermittent open-circuit. Check for an intermittent short-circuit to supply voltage.
Remedy as necessary.
Other information
- To connect the breakout box, see Connecting the breakout box
- To connect the breakout box to the transmission connector, see Connecting the breakout box, GM automatic transmissions
- For information about signals, see Signal specification
- See Checking wiring and terminals
- Continue
Refer to Information