Signal too high: Verification: Verification

HINT: After the repair it is necessary to check that the fault has been rectified. 

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector(s) Reinstallation

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.
• Wait for at least 90 seconds.
• Connect the connectors, install the components etc.
• Ignition on.
• Gear selector in position P.
• Activate solenoid S1.

  The value should change between OFF and ON.

  Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Does the value change? 

• YES 

  VERIFIED:  Troubleshooting has been completed.

• NO 

  Refer to Information 

HINT: After carrying out the repair, check that the fault has been remedied. 

Fig 1: Identifying Ignition ON

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector(s) Reinstallation

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.
• Reinstall the connectors, components etc.
• Ignition on.
• Read off the oil temperature.

  Check that the transmission oil temperature is within its permitted range.

  Compare with the transmission temperature.

  NOTE:

  The transmission temperature sensor is located inside the control unit and can be affected by the heat given off by the solenoids.

  Fig 3: Identifying VCT2000 Diagnostic Tool Symbol In VIDA

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Is the oil temperature within its permitted range? 

• YES 

  VERIFIED:  Troubleshooting has been completed.

• NO 

  Refer to Information