Installing the right-hand drive shaft on the transmission, wheel spindle and control arm

Fig 1: Identifying Rubber Seal & Constant Velocity Joint

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ensure that the rubber seal is in position on the constant velocity joint.

Fig 2: Identifying Removal Of Wheel Spindle From Control Arm

Courtesy of VOLVO CARS OF NORTH AMERICA.

Align the drive shaft in the wheel arch. Install the screw loosely in the drive shaft.

Install: 

• the mobile jack under the sub-frame. Remove both the sub-frame screws. Lower the sub-frame approximately 10 cm
• the wheel spindle on the control arm
• the lock nut loosely.

Lift the sub-frame to the bodywork. Install the screws for the frame 

Press the evaporator cable and the oil pipe into place in the sub-frame clips.