Checking the steering gear bearing in the boot at the firewall

Fig 1: Identifying Steering Gear Bearing And Boot

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that the steering gear bearing in the boot has not detached from the boot.

If it has become detached apply a little grease to the edge of the boot (around the hole). Press the bearing back down into the boot. See arrow in illustration.

Fig 2: Bending Up Outer Section Of Steering Shaft Boot

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

Check that the rubber boot is positioned correctly in the bodywork (see the arrows). Adjust if necessary. Lift up the outer section of the rubber boot.

There is a risk that noise from the transmission or engine and road noise may enter the passenger compartment.